FR120N Isolated MOSFET MOS Tube FET Module Replacement Relay 100V 9.4A 30V 161A 40V 50A Board Module

With optocoupler isolation, the control signal and the power of the controlled device are isolated, which greatly increases the rigidity of the interference.

Compatible with MCU and Arduino control board, 3V or 5V signal. High level start, low level stop, PWM speed regulation. Widely used to control the start and stop of the motor, solenoid valve and other tributary equipment. The signal input side can be welded to the terminal or pin itself, compatible breadboard. Output can be soldered to the terminal or direct wire.

Module size 33.5x17mm. There are two 2mm diameter screw holes, hole spacing 9.5mm

SPECIFICATIONS:
Breadboard Friendly  : Yes
Transistor Type: N-Channel
Max. Drain Current: 9.4A
Max. VDS: 100V

SPECIFICATIONS:
Product Type: MOSFET
Number of Channels: 1 Channel
Transistor Polarity: N-Channel
Vds - Drain-Source Breakdown Voltage: 100 V
Id - Continuous Drain Current: 9.4 A
Rds On - Drain-Source Resistance: 210 mOhms
Vgs th - Gate-Source Threshold Voltage: 4 V
Vgs - Gate-Source Voltage: 20 V
Qg - Gate Charge: 25 nC
Minimum Operating Temperature: - 55 C
Maximum Operating Temperature: + 175 C
Pd - Power Dissipation: 48 W
Dimensions: 33.5x16.6x11.5mm

*Item is not soldered!