GY-NEO6MV2 GPS Track Location Tracking Module with Antenna Flight Control NEO6 NEO6M V2 AMP2.5 for Arduino TechMakers

Do you wanna build tracking device on your precious project? This is a low cost, miniature, high performance u-blox NEO-6M GPS module with antenna and built-in EEPROM, easily plug & play with Arduino Library.

SPECIFICATION

- Model : GY GPS6MV2, NEO-6M Series version 2.0
- 50-channel u-blox 6 positioning engine boasts TTFF under 1 sec.
- Cold Start & Warm Start < 32 seconds; Hot Start : 1 second ;
- Intelligent Power Management : Eco/ Max Perform. Mode
- Operating Voltage: 3 V to 5 V ; Maximum Current : ~67mA
- UART interface (TX & RX pins), Baudrate : 9600bps (default);
- TTL level compatible with 3.3V to 5V;
- Output: Standard NMEA protocols; Positional Accuracy : 5 meter
- Passive & Active Antenna(Ceramic Can) 50dB Max Gain, 1.5dB Noise Figure
- EEPROM & Backup Battery to save data configuration when powered off
- LED signal Indicator ; Dimension : 25mm*35mm; Working Temperature: -40 to 85C;
- Antenna Size : 25*25mm

Application : Compatible with various flight controller modules that provide GPS computer test software, suitable for battery operated mobile devices with very strict cost and space constraints. Excellent navigation performance even in the most challenging environments.
Datasheet : https://www.u-blox.com/…/NEO-6_DataSheet_(GPS.G6-HW-09005).…
Arduino : http://www.instructables.com/id/Arduino-Ublox-GPS/