KY039 KY-039 Finger Pulse Heartbeat Rate Sensor; Arduino Detector Measure KY39 KY-39

Pulse monitor works as follows: The LED is the light side of the finger, and phototransistor on the other side of the finger, phototransistor used to obtain the flux emitted, when the blood pressure pulse by the finger when the resistance of the photo transistor will be slightly changed.



Product Description



The KY-039 Heartbeat Detector uses a very high resistance resistor R1, because most of the light through the finger is absorbed, it is desirable that the phototransistor is sensitive enough. The most important is to keep the shield stray light into the phototransistor. For home lighting that is particularly important because the lights at home mostly based 50HZ or 60HZ fluctuate, so faint heartbeat will add considerable noise.



Required Hardware Devices



Arduino controller × 1

USB data cable × 1

KY-039 Heartbeat Detector



Connecting



Sensor pin S connect to Arduino pin Analoog 0 / A0

Sensor pin + (middle pin) connect to Arduino pin 5+

Sensor pin – connect to Arduino pin GND







#Sensor